PROLOGY Prology HDTV-2010 sm v501-18.1 free download

File name Prology HDTV-2010 sm_v501-18.1.zip

PROLOGY HDTV-2010 COLOR TFT-LCD TV SERVICE MANUAL CAUTION !! BEFORE SERVICING THE TFT-LCD TV, READ THE SAFETY PRECAUTIONS IN THIS MANUAL. PAGE:1 SAFETY PRECAUTIONS !! Important Safety Notice !! Many electrical and mechanical parts in this chassis have special safety-related characteristics. These parts are identified by in the Schematic Diagram and Replacement Parts List. It is essential that these special safety parts should be replaced with the same components as recommended in this manual to prevent Shock, Fire, or other Hazards. Do not modify the original design without permission of manufacturer. Leakage Current Hot Check (See below Figure) Plug the AC cord directly into the AC outlet. Do not use a line Isolation Transformer during this check. Connect 1.5K/10watt resistor in parallel with a 0.15uF capacitor between a known good earth ground (Water Pipe, Conduit, etc.) and the exposed metallic parts. Measure the AC voltage across the resistor using AC voltmeter with 1000 ohms/volt or more sensitivity. Reverse plug of the AC cord into the AC outlet and repeat AC voltage measurements for each exposed metallic part. Any voltage measured must not exceed 0.75 volt RMS, which is, corresponds to 0.5mA. In case any measurement is out of the limits specified, there is possibility of shock hazard and the set must be checked and repaired before it is returned to the customer. Leakage Current Hot Check circuit PAGE:2 SERVICING PRECAUTIONS CAUTION!! Before servicing receivers covered by this service manual, read and follow the SAFETY PRECAUTIONS on page 3 of this publication. General Servicing Precautions 1.Always unplug the receiver AC power cord from AC power source before; Removing or reinstalling any component, circuit board module or any other receiver assembly. Disconnecting or reconnecting any receiver electrical plug or other electrical connection. Connecting a test substitute in parallel with an electrolytic capacitor in the receiver. CAUTION!! A wrong part substitution or incorrect polarity installation of electrolytic capacitors may result in an explosion harzard. 2.Do not spray chemicals on or near this receiver or any of its assemblies. 3.Do not defect any plug/socket voltage interlocks with which receivers covered by this service manual might be equipped. 4.Always connect the test receiver ground lead to the receiver chassis ground before connecting the test receiver positive lead. Always remove the test receiver ground lead last. 5.Do not connect the test fixture ground strap to power supply heatsink in this receiver Electrostatically Sensitive(ES) Devices Some semiconductor(solid state) devices can be damaged easily by static electricity. Such components commonly are called